Phones answered 24/7Newark, OH
Call (833) 490-5225
Phones answered 24/7Call any time(833) 490-5225
Urgent? Phones answered 24/7

Licking River flood damage cleanup in Newark and along the valley

River water pumped out, silt and soaked material removed, and the structure dried under readings after the Licking River leaves its banks.

  • Phones answered 24/7
  • Licking River and storm water
  • Estimate approved before work
  • Moisture readings logged

Get a fast quote

Fastest: call (833) 490-5225. Or send this and we call you back.

River Flood Damage

Licking River Flood Damage: what it covers

Quick answer

River flooding in Newark is cleaned in a fixed order: water out, contaminated material out, then drying. Newark Water Damage Restoration answers these calls for Licking County around the clock and sends a crew as fast as one is available. River water is treated as grossly contaminated, so porous material that soaked is removed rather than dried in place.

Licking River Flood Damage illustration for Newark, OH, with rolling hills in the background

Newark sits at a meeting of streams. The North Fork comes down from the north, the South Fork comes in from the west, and below the confluence the main Licking River carries everything downstream. That geography is the reason this is the busiest service on the site. A storm does not have to fall on your street to put water in your house; it only has to fall on enough of the drainage above you.

The USGS has published work on flooding at Newark and reports that most flood damage in Licking County has fallen along four streams: the Licking River, the North Fork, the South Fork and Raccoon Creek. If your property sits in that corridor, river flooding is a recurring condition of the ground rather than a freak event, and the right question is not whether it happens but how the building is dried and put back when it does.

River water is also not clean water. It has run over roads, fields, yards and storm drains before it reached your floor, and it carries silt that stays behind after the water leaves. That is why a river job looks different from a burst supply line: more material comes out, more surfaces get cleaned, and the drying stage does not begin until the dirty part is finished.

Service area
Newark & Licking County
Availability
Phones answered 24/7, emergencies first
Warning signs

Signs you need licking river flood damage

Do not wade into standing flood water in a basement while the power to that level is on, and do not reach into water to switch anything off. Treat river water as contaminated: no bare hands, no bare feet, and wash thoroughly afterwards. Do not restart a furnace, water heater or air handler that was submerged, and do not use a gasoline pump or generator inside the building, because the exhaust kills people in enclosed spaces every year. Leave a sagging, water-filled ceiling alone. If the water is still rising or you are unsure whether the structure is safe, get out and call (833) 490-5225.

  • A water line on the outside of the foundation or on an interior wall, with silt below it
  • Mud or fine grit left in floor corners, stair treads and door tracks after the water drops
  • Carpet and pad that squelch underfoot and stay dark long after the rain stops
  • Baseboards and door casings that have swelled, split or pulled away from the wall
  • A gritty, earthy smell in a basement or ground floor that was not there before
  • Furnace, water heater or laundry appliances that sat in standing water
  • Buckled hardwood, lifting vinyl plank, or tile that sounds hollow when tapped
  • Drywall that is dark and soft from the floor upward rather than from the ceiling down
Job stories

Typical jobs for licking river flood damage

Typical job
Illustration: Typical: river water across a ground floor on the south side

Typical: river water across a ground floor on the south side

What homeowners notice
After a long rain the river has come across low ground and stood several inches deep through a ground-floor living room and hallway, leaving silt along the baseboards and a visible line on the drywall.
What we do
The crew confirms the power to the area is off, pumps from the lowest point, lifts the carpet and pad, cuts the drywall above the wet line where readings require it, cleans the exposed framing and then sets air movers and dehumidifiers to target readings.
What to expect
The household receives dated photographs, a written removal list and the readings from each visit, and the rebuild is quoted separately once the structure is confirmed dry.

one extraction visit, then monitoring visits through the drying typical visit

Options

Types and options for licking river flood damage

Water that came in through the lowest level

This is the common pattern along the valley. The river rises, groundwater rises with it, and water enters a basement or cellar through the floor, the cove joint and any below-grade opening. It usually leaves silt on the slab and a clear line on the walls. Mechanical equipment on that level takes the worst of it, and the drying has to deal with masonry as well as framing.

Water over the first floor

Once the river is over the finished floor the job changes scale. Contents, flooring, cabinetry, lower drywall and insulation are all in contact with contaminated water, and most of the porous material is removed. Framing and subfloor are cleaned and dried, and the drying takes longer because floor assemblies hold water between layers where no air reaches.

Flooding in a manufactured or set-on-piers home

In April 2024 the river overflowed into the Canterbury Trails mobile home community and the Little Texas neighborhood on the south side of Newark. In that kind of structure water reaches underfloor insulation, ducting and belly wrap, and those hold water out of sight long after the rooms look dry. The underside has to be opened and checked, not assumed.

Still stuck? We pick up 24/7.

If it's an emergency, call now. For non-urgent licking river flood damage, send the form and we'll call you back.

How high has the Licking River actually gone at Newark?

The record crest on the North Fork gauge at Newark is 23.90 feet, set on January 21, 1959, when the National Weather Service gauge recorded the worst Ohio flooding since 1913. The next highest readings at that gauge are 20.30 feet on January 6, 2005 and 19.00 feet on January 5, 2004.

Those three dates are worth knowing because they show the shape of the risk rather than a single disaster. The 1959 event was in a different class: a historical account of it records the city water plant underwater and eight feet of water inside a Newark plant. The 2004 and 2005 crests came a year apart in the same week of January, which is what a valley town should expect from winter rain falling on ground that cannot take any more.

What should you do in the first hours after the water drops?

Photograph everything before you move it, keep people and pets out of the wet area, and do not switch on circuits or appliances that were submerged. Pull contents up out of the wet zone if you can do it safely. Then get the water out, because the clock on secondary damage starts the moment the flooding stops.

Photographs are the part homeowners skip and later need. Take them before anything is carried out, with something in frame that shows how deep the water stood, and keep the originals rather than cropped copies. Note the date and the time you first saw water inside. That record costs nothing to make and cannot be reconstructed afterwards.

The second priority is air. Opening the building up helps only when the outside air is drier than the inside air, which after a spring rain in Ohio it often is not. Running a household fan across a wet floor without dehumidification moves damp air into dry parts of the house. Removal first, then controlled drying, is the order that keeps the damage inside the rooms that flooded.

  • Photograph each room before anything is moved, including the water line on the wall
  • Keep children and pets out until the floor has been cleaned, not just pumped
  • Leave submerged outlets, panels, furnaces and water heaters alone until a trade clears them
  • Write down the depth, the date and the time water first appeared indoors
  • Do not sweep dried silt, which turns it into airborne dust

What decides the size of a river flood job here?

Depth, duration, how much porous material the water touched, how reachable the wet area is, and the age and construction of the building. Nothing is figured from a chart. The scope is measured on site, written down, explained to you, and approved before work begins.

Depth is the obvious one, but duration often matters more. Two inches that sat for a day can mean more removal than a foot that drained out in an hour, because absorption keeps going for as long as the water is there. A finished basement with carpet, pad, drywall and cabinetry carries far more removable material than an unfinished one with a bare slab and block walls.

Does a homeowners policy cover river flooding?

Flooding from a river is generally not covered by a standard homeowners policy, which is a different question from water backing up through drains. Coverage depends entirely on your own policy and whether separate flood insurance is in place. Read the declarations page and ask your agent rather than assuming either way.

This matters before the water arrives, not after. A homeowner in the valley who learns the distinction during cleanup has no way to change it. The documentation a crew produces, the photographs, the depth record and the moisture logs are useful to whichever policy applies, and they are produced the same way either way.

Nothing a restoration crew says can decide a claim, and no honest one will promise an outcome. What the work can do is leave a clear, dated record of what the water reached and what was done about it. Our guide to flood and sewer coverage in Ohio sets out the questions to put to your insurer.

Our process

How our licking river flood damage visit works

  1. Decide whether the building can be entered

    On the first call a technician asks where the water is, how deep it was, and whether the power is still on. Flooded electrical panels, submerged furnaces and gas appliances are left to the utility or a licensed trade before anyone walks in. Nothing on the cleanup schedule is worth an electrical shock.

  2. Get the standing water out

    Submersible pumps move the bulk of the depth and extractors pull what the pumps cannot reach. In a basement the water is drawn down in stages, not all at once, so saturated soil outside the wall does not push against a foundation that has lost the water holding it level. The depth is recorded as it falls.

  3. Remove the silt and the soaked porous material

    Mud is shoveled and scraped before it dries to a crust. Carpet, pad, soaked insulation and swollen particle board come out, because river water is not something you dry back into a fiber. Drywall is cut above the water line in a straight course so the cavity can be opened, cleaned and inspected.

  4. Clean and treat what stays

    Framing, masonry, slabs and joists are washed down, then treated to knock back what the water left on them. The crew works top to bottom in a room so dirty rinse does not run over surfaces already cleaned. Studs are checked for the dark staining that shows how high the water really stood.

  5. Dry the structure to numbers, not to touch

    Air movers and dehumidifiers go in once the building is clean. Readings are taken in framing, subfloor and masonry on the first visit and on every return, and the equipment stays until those readings stop falling and hold. A floor that feels dry on the surface is routinely still wet an inch down.

  6. Document the loss and set out what comes next

    Dated photographs, the depth of standing water, a list of what was removed and the moisture log are written up as the job runs. Rebuilding drywall, flooring and trim is quoted separately once the structure is confirmed dry, and the scope is explained and approved before anyone starts it.

Licking County

Why licking river flood damage is different in Central Ohio

The confluence shapes who calls. Properties on the low south side of Newark and along the river corridor downstream see repeat exposure, while ground only a short distance up the slope may never take water. Licking County has a countywide all-natural hazard mitigation plan adopted in 2021 with Newark among the participants, and the USGS has produced flood-inundation maps for the four streams that carry most of the county's flood damage.

Timing follows the valley's own pattern. The crests on record here came in January and in early April, which is winter rain and spring rain on saturated ground rather than summer thunderstorms. That means flood calls arrive in the cold half of the year, when drying is slower, outside air cannot be used freely, and an unheated flooded basement stays wet for longer than the same basement would in July.

Housing age changes the work from street to street. Newark holds a mix of pre-war and postwar houses, so one block has plaster over wood lath and a board subfloor and the next has drywall over dimensional framing. Older masonry foundations hold water in the block cores and release it slowly, which is why a drying plan here is built from readings in the material rather than from a standard number of days.

Related

Flood Water Extraction and Pumping

Getting standing water out of a building safely and in the right order, which is the step every other part of the work waits on.

Guides

Read before you book

FAQ

Licking River Flood Damage FAQs

How soon should the water come out?

As soon as it can be done safely. Absorption into drywall, subfloor and framing continues for as long as the water is in contact with them, and the standards describe clean water degrading toward contaminated within roughly a day to two days. River water starts dirty, so the driver is not contamination but material loss: the longer the water sits, the more has to be removed rather than dried. Phones here are answered 24/7 and a crew is dispatched as fast as one is available.

Can carpet that took river water be cleaned and kept?

The pad never is, and the carpet usually is not. Pad is an open, absorbent layer that holds contaminated water and cannot be reliably cleaned in place, so it comes out. Carpet itself is occasionally salvageable if it was exposed only briefly and can be removed, cleaned off site and reinstalled over new pad, but with river water that is the exception. The decision is made on the condition in front of the crew, not on a policy.

Will you dry the basement or tear it out?

Both, in that order, and only as much removal as the material requires. Non-porous surfaces such as block, concrete and framing are cleaned and dried in place. Porous finishes that absorbed contaminated water come out: pad, carpet, soaked insulation, swollen particle board and the lower band of drywall. Each removal is explained before it happens and photographed as it is done, so you can see why the line was drawn where it was.

How long does drying take after a river flood?

Longer than after a clean water loss, because the cleaning stage comes first and masonry dries slowly. There is no fixed number of days: the equipment stays until moisture readings in the framing, subfloor and walls fall to target and hold there across visits. A cold month, a deep saturation, or a floor assembly with several layers all extend it. The log of readings is what tells you where the job is, and you are welcome to see it.

Do I need a permit for the repairs afterwards?

Possibly, depending on what is being rebuilt and where the property sits. General contractor and local permit rules can apply to restoration work, so the honest answer is to check with the local building department before rebuilding structure, wiring or plumbing. That is also the right place to ask about any floodplain requirements attached to your parcel, which are a local matter and not something a restoration crew decides.

The river has flooded this house before. Is there any point drying it properly?

Yes, and arguably more point than in a house that floods once. Repeat exposure is exactly how a building accumulates rot in sill plates and joist ends, and how mold gets established in cavities that were never opened. Drying to readings each time keeps the structure sound between events. Owners in repeat-flood locations also tend to rebuild the lowest level in materials that cope better with water, which is a sensible conversation to have during the repair rather than after the next crest.

WhatsApp